Using your freezer
Setting the temperature control...
I. Insert a coin in the slot of the Temperature Control to turn it.
2.Turn control to Number 3. This setting is designed to maintain the temperature at or near 0°F ( - 173°C) under normal operating conditions.
The sliding baskets...
can be moved from side to side or removed when loading or unloading fcod below it.
To remove:
Lift baskets out.
To replace:
Lower baskets into place.
The key eject lock...
can help reduce the hazard of child entrapment.
Adjusting the temperature control...
I, Turn control to higher number for colder temper- atures.
2. Turn to lower number for less cold temperatures,
Cooling freezer first...
Allow freezer to cool 6 to 8 hours before filling with
frozen food.
NOTE: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending on room tem- perature and the number of times the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock.
If the key is lost, contact your service agency for a replacement. Always give the complete model and serial number of your freezer when requesting a re- placement key.
The | signal | light... |
|
|
| To replace: |
|
|
| ||
automatically | warns of any | unexpected | power |
|
|
| |||||
failure. |
|
|
|
|
|
| 1. Unplug | power | cord | from | outlet. |
If the | signal | light is not glowing, |
| immediately | check: | 2. Carefully snap out light cover and assembly with a | |||||
| screwdriver by inserting it under the end of metal | ||||||||||
l for power | interruption, |
|
|
| |||||||
|
|
| edge of the light. Be careful not to chip finish on | ||||||||
l for an unplugged | power cord, |
|
| ||||||||
|
| freezer |
|
|
|
| |||||
l for a burned out signal light. |
|
| I |
|
|
|
| ||||
|
| 3. Unplug | burned | out | signal | light and replace with a | |||||
|
|
|
|
|
| ||||||
|
|
|
|
| @@ new one. Signal light can be ordered from your | ||||||
|
|
|
|
| I | service | agency. |
|
|
| |
|
|
|
|
| 4. Then, snap light assembly | into place. | |||||
|
|
|
|
|
| 5. Plug power cord into outlet. | |||||
|
|
|
|
|
|
| |||||
Energy Saving Tips...
l Check lid gasket and level cabinet to ensure a good lid seal. Keeping freezer locked ensures lid closure.
l Keep lid openings to a minimum. Remove several items at one time. Keep contents organized to elimi- nate searching.
l
l
l
Fill to capacity Follow recommended procedures for freezing foods.
Set Temperature Control to provide temperatures around 0°F ( - 17.8”C). There is no need to sfore foods below 0°F.
Do not let trost build up to more than Y4 Inch (6 mm) lhlck.
5
