InstallingYourFreezer
&Prong Groundlng mpe Wall Receptacle
Retalnlng Cllp
Freezer | ’ |
|
Power | Plug | Groundlng Plug |
Clean it
Clean your freezer before using it.
1.Use a sponge, cloth or paper towel and mild detergent in warm water to clean outside and inside of freezer, lid liner and gasket.
2.Rinse and dry thoroughly
Plug it in
Recommended Grounding Method
A 115Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a re- ceptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
Attach retaining clip, from literature pack inside the freezer, over power cord plug.
See Electrical Requirements and Grounding Instruction Sheet in your Literature Package.
Install properly
l/L-
Allow room to open Ild | 2 Inches at back |
v
Check wlth level
1.Pick a safe place, indoors, away from flamma- bles such as gasoline.
2.Check the strength of the floor. It should hold the weight of a fully loaded freezer.
3.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way.
4.It should not be necessary to remove the lid during installation. If, for any reason, the hinges need adjustment, see your authorized Whirlpool dealer.
5.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
Level chest freezer
Level freezer from end to end and front to back so that the lid will seal properly. Use shim(s) to level if needed.
Install defrost drain cover (EH220FX and EH150FX)
1.Remove defrost drain cover from literature package.
2.Check drawing on page 6 for placement.
3.Install cover.
4
