Install properly...
Ikl
Allow room to open lid
2 inches at back
1 Check the strength of the floor It should hold the weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow at least 3 Inches (7.5 cm] air space on all sides of freezer and 2 inches (5 cm) at back. Leave room at top for lid to open all the way
4 It should not be necessary to remove the lid during Installation. If, for any reason, the hinges need ad-
Justment, see your authorized WHIRLPOOL dealer.
5 Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Install defrost drain coveG..
1 | Remove | cover | from | literature | package |
2 | Check | drawing | on | front cover | for placement |
3. | Install | cover |
|
|
|
Clean it ...
Clean your freezer before using It See cleaning instructions on page 6
Plug it in...
| grounding |
| |
| type wall | receptacle | n |
Retaining | Clip |
|
|
Level chest freezer.. .
from end to end and front to back so that the IId WIII seal properly.
Check with level
Remove sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer
To remove any remaining glue:
1 Rub brtskly with thumb to make a ball, then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water] be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE the Tech Sheet fas- tened under the freezer at the front.
Freezer /
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only15 or 20 ampere fused and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
Attach retaining clip over power cord plug from literature package inside the freezer.
4
