Using your freezer
Setting the temperature control...
1 Insert a coin In the slot of the Temperature Control to turn it.
2 Turn control to Number 3 This setting ISdesigned to
maintain the temperature at or near O’F ( 17.8 C)
under normal operating condrtions
The sliding basket...
Can be moved from side to side or removed when
loadrng or unloading food below it
To remove:
Loft basket out
To replace:
Lower basket intc place
The key eject lock...
can help reduce the hazard of child entrapment
Adjusting the temperature control...
1 Turn control to higher number for colder temper- atures
2 Turn to lower number for less cold temperatures.
Cooling freezer first...
1 Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2 Let It cool overnight before addlng large amount of unfrozen food.
NOTE: When freezer ISfirst started the compressor will run constantly until the cabinet is cooled. It may take
up fo 6 to 8 hours or longer, depending on room tem- perature and the number of times the freezer lid is opened.
After the cabinet IScooled the compressor wtll turn
on and off as needed to keep freezer at proper temperature
To lock or unlock the freezer you must hold the key In the lock while turning The lock IS spring loaded so the key cannot be left in the lock
If the key IS lost, conract your WHIRLPOOL
dealer for a replacement Always grve the com- plete model and serial number of your freezer
when requesting a replacement key.
The | signal | light... |
|
|
| |||||
automatically |
| warns | of | any | unexpected | power | ||||
failure. |
|
|
|
|
|
|
|
|
| |
| If the | signal | light | ISnot | glowing, | rmmedrately | check | |||
l | for | power | Interruptron, |
|
| JLB | ||||
|
|
|
| |||||||
l | for | an | unplugged | power | cord, |
| ||||
l | for | a | burned | out | signal | lrght |
|
|
I
To replace:
1. Unplug power cord from outlet
2 Carefully snap out light cover and assembly with a
screwdriver by inserting It under the end of metal edge of the light. Be careful not to chip finish on freezer.
3 Unplug burned out signal light and replace with a new one. Signal light can be ordered from your WHIRLPOOL dealer.
4.Then, snap light assembly into place
5Plug power cord into outlet.
5