Install properly.. | Install | defrost drain cover... | |
| 1. Remove cover from literature package | ||
| 2. | Check drawing on front cover for placement | |
| 3. | Install | cover. |
I. Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2.Pick a safe place, indoors, away from in- flammables such as gasoline.
3.Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches [5 cm) at back. Leave room at top for lid to open all the way.
4.It should not be necessary to remove the lid during installation. If, for any reason, the hinges need ad- justment, see your authorized WHIRLPOOL dealer.
Clean it ...
Clean your freezer before usrng it. See cleaning instructions on page6.
Plug it in...
Retaining Clip
5.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
.ISW,,i .I mUn*,rm,- ~llm.a*2 . “1111
Level chest freezer...
from end to end and front to back so that the lid will seal properly.
Freezer | 1 |
|
Power Plug | I | ‘9 |
| . - | plug |
| grounding |
Recommended Grounding Method
Remove sales labels...
Remove the Consumer Buy Guide label and any inside labels before using the freezer.
To remove any remaining glue:
1.Rub briskly with thumb to make a ball, then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] be- fore removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the materlal.
NOTE: DO NOT REMOVEthe Care 81Service label on Inside Ild or Tech Sheet on back of cabinet.
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
Attach retaining clip over power cord plug from literature package inside the freezer.
4