Install properly.. .
I, Allow 3 inches [ 7.5 cm] between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (2.5cm) between the refrig- erator condenser and the wall.
3.Allow % inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
Level refrigerator...
Levelli
1.Keep the 4 bolts that held refrigerator in shipping crate. They a:e the levelling legs.
2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator
3.Adjust each leg until the refrigerator won’t rock. Slide refrigerator into place.
4.Adjust front legs to level the refrigerator,
5.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.
To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetmchlorlde, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigemtor at the front.
Clean it.. .
Clean your refrigerator before plugging it in or usrng it. See cleaning instructions on page 7
Plug it in...
L!efrlgerotor
Powercota
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
Turn it on...
l Move run switch to RUN
NOTE: The refrigerator motor will not operate un- tll the run switch is on RUN.
4
