REFRIGERATOR

REFRIGERATOR

INSTALLATION

Unpack the Refrigerator

Unpack the RefrigeratorWARNING

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

Remove packaging materials

Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see “Refrigerator Safety.”

Clean before use

After you remove and properly dispose of all packaging materials, clean the inside of your refrigerator before using it. See the cleaning instructions in the “Refrigerator Care” section.

Location Requirements

Excessive Weight HazardWARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

Allow at least 3 in. (7.5 cm) of air space at the top, back and sides of the refrigerator. If the hinge side is against a wall, leave extra space so the door can open wider.

NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, in a location with prolonged exposure to direct sunlight, nor in a location where the temperature will fall below 40°F (5°C).

3" (7.5 cm)

3" (7.5 cm)

Electrical Requirements

Remove packaging materialsWARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection:

Recommended grounding method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

4

Page 4
Image 4
Whirlpool EL1WSRXLQ0 Refrigerator Installation, Unpack the Refrigerator, Location Requirements, Electrical Requirements