Install properly.. . | Remove sales labels.. . |
| Remove the Consumer Buy Guide label, tape and |
| any inside labels before using the refrigerator. |
| To remove any remalnlng glue: |
| 1. Rub briskly with thumb to make a ball then remove. |
| OR |
| 2. Soak area with dishwashing detergent solution (1 |
| teaspoon detergent in 1 quart warm water) before |
| removing glue as described in step 1. |
| DO NOT USErubbing alcohol or flammable or |
| toxic solvents, such as acetone, gasoline, car- |
| bon tetrachloride, etc. These can damage the |
| materlal. |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- |
| STRUCTION LABELS INSIDE YOUR REFRIGERATOR. |
| Do not remove the Tech Sheet tastened under |
| the refrlgemtor at the front. |
| Clean it.. . |
1.Allow 3 inches (7.5 cm] between overhead cab- inets and the refrigerator top.
2.Allow at least an Inch (2.5 cm) between the refng- erator condenser and the wall.
3.Allow % inch (1.25 cm] on each side of the re- frigerator for ease of rnstallation.
4.If the refrigerutor is to be against a wall, you might want to leave enough space so the door can be opened wider
Clean your refrtgerator before using it. See clean rng instructions on page 8
Plug it in...
Level refrigerator-freezer...
Use Screwdriver | leveling | screw |
to Adjust |
|
|
left to lower
1 To raise front, turn each screw to the right 2 To lower front, turn each screw to the left 3 Check with level
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extenslon cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4