Install properly.. . | Remove sales labels.. . |
|
| ||||
| . | Remove the Consumer Buy Guide label, | tape and | ||||
| any lnslde labels before using the refrigerator | ||||||
| To remove any remaining glue: |
|
| ||||
| 1. | Rub briskly | with thumb | to make | a ball then | remove. | |
| OR |
|
|
|
|
| |
| 2. | Soak area | with dishwashing | detergent | solution (1 | ||
|
| teaspoon | detergent | in 1 quart | warm water] | before | |
|
| removing glue as described in step 1. |
|
|
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachlorlde, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front. | ||
ib, | ^I. |
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions 4 on page 8,
1.Allow 3 inches (7.5 cm) between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (25cm) between the refrig- erator condenser and the wall.
3.Allow l/z inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
Level refrigerator-freezer...
Use Screwdriver | leveling screw | Raise” | I |
to Adjust |
|
|
|
Lefl to lower
1.To raise front, turn each screw to the right.
2To lower front, turn each screw to the left
3.Check with level.
Retrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments und grounding instruction sheet in your liter- ature package.
4