Whirlpool ET16JM Removing crispers and crisper cover, Adjusting the shelves, Automatic ice maker

Adjusting the shelves.. .

I, First, remove food from shelf.

2.Slide shelf straight out to stop.

3.Lift front.

4.Slide the rest of the way out.

Replacing Shelf:

I. Fit back of shelf on top of guides with wire stops

on the bottom of guides.	Shelf Guide
2. Lift front, slide shelf In until it clears guide stops.

Removing crispers and crisper cover.. .

Removlng the	Crispers:	Lilt the Front, Then the Back.
1. Slide crisper	straiaht out to stop, lift front, then slide	I	I IIIf I
the rest of the wai out.
2. Replace in the reverse order.

Removing Cover:

1.Lift front and remove the cover support.

2.Lift out cover by pulling up and out.

Replacing Cover:

I, Fit back of cover into notch supports on walls of

refrigerator, then lower front into place.
2. Replace cover support with	the	long tab towards		‘ull	out	to stop.
the front. Note: If support needs		adjustment, turn
			me	Front and	Pull	Again.
base right to raise, or left to	lower.

Changing the light bulb...

WARNING: Before removlng the light bulb, either unplug the refrlfjeratoror dlrconnect

the electricity leading to the re- frigerator at the main power supply. Shock and injury can occur if elec- tricity remains connected.

Automatic ice maker.. .

Raise Slgnal

Arm to Stop Ice Maker.

lower Slgnal Arm to Start It.

If you have Model ET16JM and have the automatic ice maker accessory, or if you have Model ET16JKand plan to add one later [Part No. ECKMF-83). there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down...for making ice automatically; Up,, .to shut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

l It is normal for ice crescents to be attached by a corner. They will break apart easily.

l Ycu WIII hear water running when ice maker IS working. You’ll hear ice fall into the bin Don’t let these sounds bother you.

l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

Unplug Ke refrigerator first.

1. Reach behind control console to find bulb.

2. Remove bulb.

3. Replace with a 40.watt appliance bulb. a-Bm*l~~w IKSSGuwm---IR-

l Because of new plumbing connections, the first ice may be discolored cr off-flavored. Discard the first few batches of ice.

l If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and. if necessary, turn the Freezer Control toward A.

l If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position.

l If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

. Good water quality is important for good ice quality It is not recommended that the ice maker be con- nected to a softened water supply Water softener chemicals such as salt from a malfunctioning soft- ener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water soft- ener be well maintained and operating properly.

6