Install properly.. . gf 1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top
2 Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm) on each side of the re-
frrgerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider. ru-*smte
Level refrigerator-freezer.. . Right to Raise;
left to lower Leveling screw II
Raise I
Use Screwdriver
to Adjust
1 To rarse front. turn each screw to the right
2 To lower front, turn each screw to the left
3 Check with level
Remove sales labels.. . Remove the Consumer Buy Guide label and other
Inside labels before usrng the refrigerator. Any glue
left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrigerator at the front.
.i i ..s,
~~.vATses-.s5 -?AAlmbel SW. vz;.r’“.**.w-” s,eG..esYmx* .I .& I I h.SxeW
Clean it.. . Clean your refrigerator before using it. See clean-
rng instructions on page 8.
Plug it in... t
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4