Install Properly.. . Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
Allow l/z inch (1.3 cm) between counters and
sides of refrigerator.
Allow at least 1 inch (2.5 cm) between the con-
denser and the wall.
If the refrigerator is to be in a corner, keep 1%
inches (3.1 cm) between the wall and the side of
the refrigerator so there is room to open the doors
wider.
level Refrigerator-Freezer.. . I. Remove base grille [see page 5).
2. To raise front, turn each leg to the left.
3. To lower front, turn each leg to the right.
4. Check with level.
Remove Sales labels... Remove the Consumer Buy Guide label and any
inside sales labels before using the refrigerator. Re-
move any left over glue with rubbing alcohol.
Clean your refrigerator before using it. See clean-
ing instructions on page 7.
Plug It In... wall receptacle
J-drong
A grounding plug
t
Refrigerator
Power Cord
Recommended
Grounding Method
A 120 Volt, 60 Hz., AC only, 15 ampere fused elec-
trical supply is required. It is recommended that a
separate circuit serving only this appliance be
provided.
Do not use an extension cord. Use a receptacle
which cannot be turned off with a switch or pull
chain. See individual electrical requirements and
grounding instruction sheet in your literature
package.
3