InstalI properly.. .
You don’t need space between counters and cabinets and the sides and top of the refrigerator. You might want to leave enough room so the refrigerator can be rolled easily
The refrigerator back can be flush against the wall.
If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
4
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any lnslde labels before using the refrigerator.
To remove any remalnlng glue:
I. Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachlorlde, etc. These can damage the materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the retrlgerator at the tront.
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions on page 9.
Level refrigerator-freezer.. .
Front Roller
Right to Raise;
Left to Lower
1.Remove base grille (see page 7).
2.To raise front, turn each screw to the right.
3.To lower front, turn each screw to the left.
4.Check with level.
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extenslon cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
