Adjusting the shelves... I. First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lrft front.
4. Shde the rest of the way out.
Replacing Shelf:
Shelf Stop a
I. Frt back of shelf on top of guides wrth wire stops
on the bottom of gurdes.
2. Lift front, slide shelf in until It clears guide stops.
Removing crispers and crisper cover.. . Removing the Crispers:
I, Slide crisper straight out to stop,
III?
front, then slide
the rest of the way out
2. Replace in the reverse order.
Removing Cover:
I, Lift front and remove the cover support
2. Lift out cover by pulling up and out.
Replacing Cover:
I, Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab towards ,
the front.
Note:
If support needs adjustment, turn
base right to lower, or left to raise.
Lift the Front, Then the Back.
Lift the Front!r?!j%rttl?~~~:
Changing the light bulb.. . WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re-
frigerator at the main power supply.
Shock and injury can occur if elec-
tricity remains connected.
1. Reach behind control console to find bulb.
2. Remove bulb
3. Replace with a 40.watt appliance bulb
Automatic ice maker.. . If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-83), there are
a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down,, .for making ice automatrcally;
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
Lower Sig;lal \ Raise Signal
Arm to Start It. Arm to Stop Ice Maker.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water runnrng when ice maker is
working, You’ll hear ice fall into the bin. Don’t let
these sounds bother you.
l
The ice maker will not operate until the freezer IS
cold enough to make ice, This con take overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
l
If you remove the Ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
l
The ice maker water supply
should not be soft-
ened water.
The chemicals could damage the ice
maker molds.
6