Using your freezer
Adjusting Cold Control...
l Turn control to higher number for colder temperatures.
l Turn to lower number for less cold temperatures.
Setting the Cold Control...
1.Insert a coin in the slot of the Cold Control to turn it.
2.Turn control to Number 3. This setting will main-
tain zero zone temperatures under normal op- erating conditions. The control will be set about right when ice cream stored inside the freezer is firm.
Cooling Freezer First...
l Allow freezer to cool 6 to B hours before filling with frozen food.
l Let it cool overnight before adding large amount of unfrozen food.
Note: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times the freezer door is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
The outside of your freezer may feel warm. This is normal. The freezer’s design and main function is to remove heat from packages and air space inside the freezer. This heat is transferred to the room air so the walls of the freezer may be warm.
Exterior Signal light...
automatically warns of any unexpected power failure.
Signal light cover
If the signal light is not glowing, immediately check:
l for power interruption, blown fuse or tripped circuit breaker;
l the power plug; it may be disconnected from the outlet,
l the signal light; it may be burned out.
To replace burned out signal light:
1.Unplug power cord from outlet.
2.Carefully snap out light cover and assembly
with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.
3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your Whirlpool dealer.
4.Then, snap light assembly into place.
5.Plug cord into outlet.
Freezer Shelves...
To remove:
Lift front slightly, then lift she !If from back sufsports
To replace:
Set back of shelf on rear supports then lower the front on to front mounts,
Lift the front
Then the bat
