Using your freezer
Setting the temperature control...
I. Insert a coin in the slot of the Temperature Control to turn It.
2.Turn control to Number 3. This setting ISdesigned to maintain the temperature at or near 0°F ( ~ 179°C) under normal operating conditions.
Adjusting the
temperature control...
l Turn control to higher number for colder temper- atures.
l Turn to lower number for less cold temperatures.
Cooling freezer first...
lAllow freezer to cool 6 to 8 hours before filling with frozen food.
l Let it cool overnight before adding large amount of unfrozen food.
NOTE: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending vn room tem- perature and the number of times the freezer door is opened.
After the cabinet is cooled the compressor WIII turn ON and OFF as needed to keep freezer at proper temperature.
The outside of your freezer may feel warm. This is nor- mal. The freezer’s design and main function is to re- move heat from packages and air space inside the freezer, This heat is transferred to the room air, so the outside walls of the freezer may be warm.
The signal light...
automatically warns of any unexpected power failure.
Signal light cover
If the signal light is not glowtng, immediately check: l for power interruptlon,
l for an unplugged power cord, l for a burned out slgnal light.
To replace:
I. Unplug power cord from outlet.
2 Carefully snap out light cover and assembly with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer
3 Unplug burned out signal light and replace with a new one. Signal light can be ordered from your WHIRLPOOL dealer
4.Then, snap light assembly into place.
5Plug power cord into outlet
Removing | the freezer | shelf... | ||
To move | shelf: |
|
| |
1 | Lift front | slightly | Lift the Front | |
2 | Loftback | off | rear supports | Then the Bock. |
3 | Replace shelf in reverse order on desired support | |||
| level |
|
|
|
Energy saving tips...
You can help your freezer use less electricity
l Check door gasket and level freezer to assure a good door seal
l Keep door openings to a mlnlmum Remove several items at one time Keep contents organized to ellml- note searching
l Fill to capacity Follow recommended procedures for freezing foods See pages 7 and 8
l
l
Set Temperature Control to provide temperatures around 0 F ( 17 8 C) There IS no need to store foods below 0 F
Do not let frost build up to more than ‘/4Inch (6 mm] thick Efficiency is reduced
