Install properly, Level freezer, Remove sales labels

Install properly..

2 Inches

00 Ii

1.Check the strength of the floor It should hold the weight of a fully loaded freezer

2-inch spacer

2 Pick a safe place, indoors, away from inflam- mables such as gasoline.

3.Spacers are packed In the freezer. Install them as shown to keep freezer at least 2 inches (5 cm) from

the wall

4 Remove the shrpprng block.

5. Allow at least 3 inches (7 5 cm] air space on top and each side of the freezer

6 Do not cover the freezer with Items such as blankets, sheets, tablecloths, etc

I. Slide freezer into place.

2 Level freezer using wood shims so that door will stay open at any position.

Remove any labels before usrng the freezer To remove any remaining glue:

1 Rub brrskly with thumb to make a ball then remove

2 Soak area with drshwashlng detergent solutron (1 teaspoon detergent In 1 quart warm water] be- fore removing glue as descrrbed in step 1

DO NOT USE rubbing alcohol or tlammable or toxic solvents, such as acetone, gasoline, car-

bon tetrachloride, etc. These can damage the material.

NOTE: DO NOT REMOVE the Tech Sheet on the back of the cabinet.

Clean your freezer before using it See cleanrng InstructIons on page 6

3-prong groul nding type wall receptacle

Retaining Clip

Freezer 1

Power Plug

grounding plug

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit

serving only this appliance be provided. Use a

receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord. See individual “Electrical Requirements and

Grounding Instructions” provided with your product.

Attach retaining clip over power cord plug from literature package inside the freezer.