Changing the light bulb...
light Shield
WARNING: To avold possible shocks, first unplug freezer or turn off electrlclty leadlng to freezer at the maln power supply.
I. Remove the light shield from the side of the control panel. Depress the back of the shield to release the tabs, then pull away.
2.Replace bulb with a
3.Replace the light shield. Insert the shield tabs in the slots, then press the shield to snap into place.
4.Plug in power cord or switch on electricity
Removing the bottom trivet ...
To remove:
1 Lift front of trivet out of supports
2Pull out
To replace:
1 Position bock of trivet on the rear wall supports 2 Lower front into place
Lift the Front,
Then Pull Out.
The key eject lock...
can | help | reduce | the hazard | of child | To lock | or | unlock the | freezer | you | must hold the | |||||
entrapment |
|
|
| key | in | the lock | while | turning. | The | lock | is spring | ||||
|
|
|
|
| loaded so the key cannot be left in the lock. | ||||||||||
|
|
|
|
| If | the | key | is | lost, | contact | your | WHIRLPOOL | |||
|
|
|
|
| dealer | for a | replacement. | Always | give | the com- | |||||
|
|
|
|
| plete model and serial number of your freezer | ||||||||||
|
|
|
|
| when |
| requesting | a | replacement | key. |
|
The signal light...
automatically warns of any unexpected power failure.
Signal Light
/
If the signal light is not glowing, immediately cl ieck:
0 for power interruption,
l for an unplugged power cord, l for a burned out signal light.
To replace burned out slgnal light:
I. Unplug power cord from outlet.
2.Open the freezer door
3.Unplug burned out light and replace with one of same wattage and size. Signal light can be ordered from your WHIRLPOOL dealer,
Part No. 1103680
4.Close freezer door and plug power cord into outlet.
6