Install properly.. .
Flush against back wall and cabinets
1.Check the strength of the floor. It should hold the weight of fully loaded freezer.
2.Pick a safe place, indoors, away from in-
flammables such as gasoline.
3.Allow I/Z” (.2 cm) space on each side and at top for ease of installation.
Level freezer.. .
so that door will stay open at any position.
I. Remove base grille (see page 7).
2.To raise front, turn each leg to the left.
3.To lower front, turn each leg to the right.
4.Check with level.
5. After freezer is fully loaded,recheck | with level |
4
Remove sales labels.. .
Remove the Consumer Buy Guide label and any inslde labels before using the freezer. Re- move a.Iv left over alue with rubbing alcohol.
above the Temperature Alarm Switch or
Clean it,. . | A P | |
|
CI:?an your freezer before using it. See Clean- ing
lnstal I the battery.. .
You M II find the freezer key and a
The TEimperature Alarm will sound a continu- ous ton6 if the Temperature Alarm Switch is in the ON or Tk ST position. Move the switch to OFF until the free !er is cold. Then move it to ON.
Plug ilt in...
| IFreezer |
|
|
|
|
| ||
| power | cord |
|
|
|
|
| |
| RECOMMENDED GROUNDING METHOD |
| ||||||
A 115 i’olt, 60 Hz, AC only | 15 or | 20 | ampere | fused | ||||
and | prc perly | grounded | electrical |
| supply | is re- | ||
quired | is | recommended | that | a | separate | circuit | ||
serving | I lnly | this | appliance | be | provided |
| ||
Do nclt use an extension | cord. | Use a | recep- |
tacle which cannot be turned off with a switch
or pull chain. See individual electrical require-
ments a Ed grounding instruction sheet in your Iiter- ature pc:ckage