Before you plug it in
Before using your freezer, you are personally responsible for making sure that it...
l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l is connected only to the right kind of outlet,
with the right electrical supply and grounding.
l is used only for jobs expected of home freezers.
l is not near an oven, radiator or other heat source.
Install Properly.. .
lis prc perly maintained.
lis in cddry sheltered place.
l is use83 in an area where the room tempera- ture vill not exceed 110°F(433°C).
l is not run where there are explosive fumes.
l is not Ilsed by children or others who may not understand how it should be used.
l is not loaded with food before it has time to get properly cold.
Remove Sales labels...
Rem’)ve the Consumer Buy Guide label and any inm#ide labels before using the freezer. Re- move crny left over glue with rubbing alcohol.
INotcr: DC NOT REMOVE the Tech Sheet fas- tene.1 behind the base grille.
I
1 inch in back1 | Cleaii | It... |
| |
Clean your freezer before using it. See clean- | ||||
| ||||
| ing instructions on page | 5, | ||
| Plug | it in... |
|
1.Check the strength of the floor It should hold the weight of fully loaded freezer.
2.Pick a sate place, indoors, away from in-
flammables such as gasoline.
3.Allow at least 3 inches (7.5 cm] air space on top of freezer and 1 tnch (2.5 cm] at back be- tween condenser and wall.
level Freezer.. .
so that door will stay open at any position.
1. | Remove | base grille | (see | page | 4 1. 7 | 1 | |||
2. | Starting | with | door | hinge |
| sid |
|
| |
| turn | left | to raise corner. |
|
|
|
| ||
3. | Turn | right to | lower | corner |
|
|
| ||
4. | Check | with | level |
|
|
|
|
| |
5. | After | freezer | is loaded | with |
|
| |||
| food, | recheck | with | level. |
|
|
| ||
2 |
|
|
|
|
|
|
| Raise | Lower |
|
|
|
|
|
|
|
|
|
Freeze1 power .:ord
Recommended Grounding Method
A 12L Volt, 60 Hz., AC only, 15 ampere fused electric al supply is required. It is recommended that a separate circuit serving only this appli-
ance t e provided. The receptacle should not be conlrolled by a wall switch or pull chain.
Do not use an extension cord.
See ndividual electrical requirements and
grounding instruction sheet in your literature packa! re.