Whirlpool FGP300JN0 installation instructions

selector key

orifice spuds	Remove and replace
	orifice spuds.

notches

NAT L.P.

Note: Burner tube and

brackets not shown. gas manifold

L.R. L.F. R.R. R.F.

5.Locate Natural gas orifice spuds in literature package included with the range. All Natural gas spuds are stamped with “145”. Remove L.P. gas orifice spuds using a 3/8" combination wrench. Install Natural gas orifice spuds to replace the L.P. gas orifice spuds.

Place L.P. gas orifice spuds in plastic parts bag for future use and keep with literature package.

Reinstall burner tube and bracket assemblies. Do not lower cooktop.

oven burner orifice behind air shutter

L.P. gas decrease gas decrease flame size

pin hood

Natural gas increase gas

increase flame size

pre-set at factory for Natural gas

6.Oven burner: Use 1/2" combination wrench to loosen the orifice hood away from the pin (approximately 2 to 2-1/2 turns). The burner flame cannot be properly adjusted if this conversion is not made.

gas		thermostat
manifold	N	L
	A	P
	T

7.Locate selector key on oven thermostat and turn counterclockwise to the Natural position.

8.Lower cooktop. Reinstall screws to secure burner tubes to cooktop. Reinstall burners and grates.

9.Complete section E “Check operation,” Page 6. Check for proper flame. Natural gas flames do not have yellow tips.

Page 8