PROBLEM

 

POSSIBLE

 

CAUSE

Burner

 

flames

are

Burner

ports

are clogged.

uneven

 

 

 

 

 

 

 

 

 

 

 

Burner

 

flames

lift

 

 

 

 

 

 

 

off

ports,

are

 

 

 

 

 

 

 

 

yellow,

 

or

are

 

 

 

 

 

 

 

 

noisy

when

 

 

 

 

 

 

 

 

turned

 

off

 

 

 

 

 

 

 

 

 

Burner

 

makes

 

Burner

is wet

from

washing.

popping

noise

 

 

 

 

 

 

 

 

when

on

 

 

 

 

 

 

 

 

 

Control

 

knob(s)

 

You are not pushing

in before

will

not

turn

 

turning.

 

 

 

 

 

 

Self-Cleaning

 

The Oven Selector

and Oven

cycle

will

not

 

Temperature

Control

are not set

operate

 

 

 

to CLEAN.

 

 

 

 

 

 

 

 

 

 

 

The range clock does not show

 

 

 

 

 

 

the correct time of day.

 

 

 

 

 

 

The Lock Lever is not in the

 

 

 

 

 

 

CLEAN position-all the way to

 

 

 

 

 

 

the right.

 

 

 

 

 

 

 

 

 

 

 

The Stan Time Dial does not

 

 

 

 

 

 

show the correct time of day or

 

 

 

 

 

 

the knob is not all the way out.

 

 

 

 

 

 

The Stop Time Dial is not set

 

 

 

 

 

 

ahead to the time you want the

 

 

 

 

 

 

cleaning

cycle

to

stop.

Cooking

results

 

The range is not

level.

are

not

whet you

 

 

 

 

 

 

 

expected

 

 

 

The oven temperature seems too

 

 

 

 

 

 

 

 

 

 

 

 

low or too high.

 

 

 

 

 

 

 

 

 

 

The oven was not preheated as

 

 

 

 

 

 

the recipe calls

for.

 

 

 

 

 

 

 

The recipe has never been

 

 

 

 

 

 

tested or is not from a reliable

 

 

 

 

 

 

source.

 

 

 

 

 

 

 

 

 

 

 

 

The pans are not the type or size

 

 

 

 

 

 

recommended

 

in the

recipe.

 

 

 

 

 

 

There is not proper air circulation

 

 

 

 

 

 

around

pan when

 

baking.

 

 

 

 

 

 

Flame size does not fit the

 

 

 

 

 

 

cooking

utensil

being

used.

When broiling, you have not completely closed the oven door.

SOLUTION

Clean with a straight pin (see pages 23 and 25). If this fails, call an authorized Roper service technician for service.

Contact an authorized Roper service technician to check air/gas mixture.

Let dry.

Push control knob(s) in before turning to a setting.

Set both the Oven Selector and Oven Temperature Control to CLEAN.

Reset clock to show the correct time of day. (See page 11.)

Move Lock Lever all the way to the right.

Reset the Start Time Knob to show the correct time of day. Pull knob out all the way.

See Step 3 in “Setting the controls” on page 20 for proper setting instructions.

Level range. (See Installation Instruc- tions.)

Adjust the oven temperature control. (See “Adjusting the oven temperature control” on page 13.)

Preheat oven if called for in recipe.

Use only tested recipes from a reliable source.

Refer to a reliable cookbook for recom- mended pan type and size.

Allow 1% to 2 inches (4-5 cm) on all sides of the pans for air circulation. There must be a minimum space of 1 inch (2.5 cm).

Adjust flame size to fit cooking utensil.

Completely close oven door.

28

Page 28
Image 28
Whirlpool FGS385Y manual Cause