Whirlpool GB2SHKLLS00 manual Freezer Features, Crisper Humidity Control, Full-Width Wire Shelf

To remove the crisper(s) cover:

1.Remove crisper(s).

2.Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Carefully, slide the glass insert forward to remove.

3.Lift the cover frame up and remove it.

To replace crisper(s) cover:

NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled in the front edge of the crisper cover.

1.Fit back of cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place.

2.Slide rear of glass insert into cover frame and lower front into place.

Crisper Humidity Control

(on some models)

You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and HIGH.

LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins.

■Fruit: Wash, let dry and store in refrigerator in plastic bag or crisper. Do not wash or hull berries until they are ready to use. Sort and keep berries in original container in crisper, or store in a loosely closed paper bag on a refrigerator shelf.

■Vegetables with skins: Place in plastic bags or plastic container and store in crisper.

HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables.

■Leafy vegetables: Wash in cold water, drain and trim or tear off bruised and discolored areas. Place in plastic bag or plastic container and store in crisper.

FREEZER FEATURES

Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word “Accessory.” Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the cover or in the “Assistance or Service” section.

Full-Width Wire Shelf

To remove and replace the shelf:

1.Remove items from the shelf. Remove the shelf by pulling it forward.

2.Replace the shelf by sliding it back in until it locks into place.

Ice Shelf

To install and remove ice shelf:

1.Slide rear L-shaped groove of shelf down over rear wall screw. Push rack back until screw is stopped in L-shaped groove.

2.Place front groove over front wall screw and push down until shelf is secured.

3.To remove, reverse above steps.

HIGH LOW

Utility or Egg Bin

(on some models - Accessory)

Depending on your model, you may have a one, two or three piece bin. Eggs may be stored in the egg tray or loose in the bin.

NOTE: Store eggs in a covered container for long-term storage. If your model does not have an egg storage bin, store eggs in their original carton on an interior shelf.

Wire Basket

To remove and replace wire basket:

1.Remove all items from basket. Remove the basket by lifting the front of the basket and pulling it forward.

2.Replace the wire basket by lifting the front while sliding the basket into place.

12