2-4
DOOR AND HINGE REPLACEMENT
1. If removed, replace both bottom hinges
and tighten the screws.
2. Carefully feed the dispenser tubing through
the bottom left hinge before replacing the
freezer door on the hinge.
NOTE: Provide additional support for the doors
while the top hinges are being replaced. Do not
depend on the door magnets to hold the doors
in place while you are working.
3. Reconnect the water dispenser tubing
by pushing the tubing into the fitting until
it stops, and the black mark touches the
face of the fitting (see Illustration 3). On
some models, replace the tubing in the
hose clip.
4. Align and replace the top left hinge (see
Illustration 4) and tighten the screws.
5. Reconnect the wiring plug.
6. Replace the left hinge cover and screws.
7. Carefully lift the refrigerator door and set
it on the bottom right hinge.
8. Align and replace the top right hinge (see
Illustration 6).
9. Replace the hinge cover and screws.
10. Plug in refrigerator or reconnect power.
DOOR CLOSING AND ALIGNMENT
Door Closing
1. Move the refrigerator into its final posi-
tion.
2. Place a level inside the refrigerator at the
back of the top shelf (see Illustration 8).
3. Locate the leveling screws behind the base
grille of the refrigerator on either side.
4. Use a hex-head socket wrench and adjust
the rear roller leveling screws until the
refrigerator is level. Turn the rear roller
leveling screw to the right to raise that
side of the refrigerator, or to the left to
lower it (see Illustration 9). Make sure the
refrigerator is level before proceeding.
Door Alignment
If the doors are uneven after leveling the
refrigerator (see Illustration 10), perform the
following steps.
1. Use a hex-head socket wrench and adjust
the front roller leveling screws until the
doors are even. Turn the front roller leveling
screw to the right to raise that side of the
refrigerator, or to the left to lower it (see
Illustration 11).
NOTE: Open and close both the refrigerator
and freezer doors after each adjustment to
check the door alignment.
2. Open the doors and replace the base
grille. Align the grille with the bottom of the
cabinet and reattach with the screws.
NOTE: Be sure to refasten the Tech Sheet
behind the base grille.
1. Do not remove screw 1
2. Wiring plug
1
2