3-wire connection: Direct wire
Use where local codes permit connecting
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed.
Strip 3¹⁄₂ in. (8.9 cm) of outer covering from end of cable. Strip insulation back 1 in. (2.5 cm). If using
When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw. See example below.
1.Loosen or remove center terminal block screw.
2.Place the hooked end of the neutral wire (white or center wire) of power supply cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw.
1 | 3 |
2 | 4 |
| 5 |
4.Tighten strain relief screws.
5.Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with
Optional 3-wire connection
Use for direct wire or power supply cord where local codes do not permit connecting
1.Remove center terminal block screw.
2.Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Connect appliance ground wire and the neutral wire (white or center wire) of power supply cord/cable under center, silver colored terminal block screw. Tighten screw.
3.Connect the other wires to outer terminal block screws. Tighten screws.
4.Tighten strain relief screws.
5.Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with
6.Connect a separate copper ground wire from the external ground connector screw to an adequate ground.
1 | 2 |
|
3
4
1.External ground connector
2.Neutral grounding wire (green/yellow)
3.Center
4.Neutral wire (white or center wire)
5.³⁄₄ in. (1.9 cm)
3.Place the hooked ends of the other power supply cable wires under the outer terminal block screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
1.External ground connector
2.Neutral grounding wire (green/yellow)
3.Neutral wire (white or center wire)
4.Grounding path determined by a qualified electrician
11
