As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

CleaningtheDryerInterior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed.

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments which contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to prevent dye transfer.

RemovingAccumulatedLint

From Inside the Dryer Cabinet

Lint should be removed every 2 years or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

VacationandMovingCare

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Close shutoff valve in gas supply line.

3.Clean lint screen. See “Cleaning the Lint Screen.”

Moving care

1.Unplug the power supply cord.

2.Close shutoff valve in gas supply line.

3.Disconnect gas supply line pipe and remove fittings attached to dryer pipe.

4.Cap the open fuel supply line.

5.Make sure leveling legs are secure in dryer base.

6.Use masking tape to secure dryer door.

ChangingtheDrumLight

The dryer light automatically turns on inside the dryer drum when you open the door.

To change the drum light

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

20

Page 20
Image 20
Whirlpool GGW9260 manual CleaningtheDryerInterior, RemovingAccumulatedLint, VacationandMovingCare, ChangingtheDrumLight