Whirlpool GH9177XL manual 0137, Progress Bar, Start, JET Cook Feature, Cancel Off

3.Touch “Poultry.” Display shows:

Poultry

Breast	Breast
Bonelss	Bonelss
Poached	Pan Brown
Pieces	Chicken

See “Learning Mode” section to see how to practice navigating through the menus without turning on the microwave generator.

See “Display Brightness and Contrast” section to see how to adjust display settings.

Progress Bar

Bone-In	Tenders
BACK	Ground

1

Sensing

Reheating

4.Touch “Pieces, Bone-In.” Use number pads to enter weight. Display shows:

Pieces BONE-IN

Cooks 0 . 5 - 2 . 0 Pounds.

1.5pounds

ENTER AMOUNT. PRESS

PREPARE, DONENESS, OR START.

Prepare Doneness

_+

BACK Start

5.Touch “Doneness” if desired. (See “Doneness” in the “Oven Use” section.) Display shows:

Doneness

Press + button to

change don eness level .

LESS	NORMAL	MORE
Nor mal is lowest		+
level allowed for

this food .

BACK Start

6.Touch “Start.” While cooking, Display shows:

01:37

Cooking

When cooking is over, display shows:

End

Let stand 3 minutes

covered.

Remove food or

press Warm Hold.

Warm

Hold

1. Progress bar

The progress bar is a visual picture of the estimated running time of a cooking cycle. It will appear during sensor cooking functions. The line appears below the word “Sensing,” and shows progress by the darkening of the line from the left. After the sensor is finished sensing, the remaining cook time replaces the word “Sensing” at the top of the display, but the progress bar continues to be displayed.

Start

The START control will start any function.

If cooking is interrupted, touching the START control pad will resume the preset cycle.

For added convenience, the “Start” touch pad is also available on some display screens, and provides the same function as the START control pad.

JET COOK™ Feature

Five of the JET COOK™ controls share function with the numerical pads 1-5. When one of these JET COOK™ controls is touched (while no function is operating), the oven will begin cooking at high power for 1-5 minutes, depending on which pad is touched. After cooking begins, the JET COOK™ controls return to their normal numerical pad function.

The JET COOK FOR 30 SEC. control starts the oven at 100% power for 30 seconds, and adds 30 seconds of cook time with each additional touch of the control. Once cooking begins, cook power or cook time may be changed manually by touching the appropriate display area and entering the numerical information.

Cancel • Off

The CANCEL•OFF pad stops most functions except for the Timer, Child Lock and Learning Mode.

The oven will also turn off when the door is opened. Close the door and touch START or the “Continue” display area to resume the cycle. A sensor cooking cycle may not be resumed if interrupted by opening the door.

8