If your dryer is gas and has a full front panel, remove front panel as follows:
1.Unplug the power supply cord or turn off the electriil power.
2.Open lint screen lid. Remove two xrews from lint screen area.
3.Open top by pulling forward and up at each front cOrner (see view A). Rest raised top against wall behind dryer (top is hinged
at rear).
4.Remove two internal screws from front panel flanoes (near toci front comers). Lii front panel sligkly, king oh bwer dips (see view B): Slowly pull front panel forward, disengaging panel from drum. (Drum will drop slightly.)
5.Move front panel aside and rest edge against side of dryer. Avoid disconnecting wire clips (see view C) or damaging wires.
6.Remove lint from area shown in pas dryer illustration on page 11 with soft brush or vacuum cleaner. Avoid damaging wires, funnel or igniter.
7.Reassemble in reverse order. Before closing the top, chedc the following:
-Drum seal must be flared out (see view D) and properly positioned against panel at bade of drum. Rotate drum countercbck- wise one full turn to check drum seal.
-Bet! should be centered and tight on dryer drum.
-Wire clips which hold the door switch wires must be anchored in sbt in top of front panel (see view C) and along top edge of side panel. Door wires must not touch drum when dryer is operating. Sm Warning, page 11.
8.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.
9.Reconnect power and level dryer again (I necessary).
NOTE: Call Consumer Assistance at
Removaaoraw
befom opatlng top
Drum seal | Side wand |
(aw vlei B)
Wire dlp- holds door
8
4
VkWB
12
