If your dryer is gas and has a full front panel, remove front panel as follows:
1. | Unplug the power supply cord or turn off the |
| electrical power. |
2. | Open lint screen lid. Remove two screws from |
| lint screen area. |
3. | Cpen top by pulling forward and up at each |
| front corner (see view A). Rest raised top |
| against wall behind dryer (top is hinged |
| at rear). |
4. Remove two internal screws from front panel | |
| flanges (near top front comers). Lii front panel |
| slightly, lifting off lower dips (see view B). |
| Slowly pull front panel forward, disengaging |
| panel from drum. (Drum will drop slightly.) |
A
Removsecrewr betom opening 1op
5. Move front panel aside and rest edge against |
side of dryer. Avoid disconnecting wire clips |
(see view C) or damaging wires. |
6. Remove lint from area shown in “gasdryer |
illustration on page 15 with soft brush or |
vacuum deaner. Avoid damaging wires, |
funnel or igniter. |
7. Reassemble in reverse order. Before closing |
the top, check the following: |
- Drum seal must be flared out (see view D) |
and properly positioned against panel at |
back of drum. Rotate drum countercbck- |
wise one full turn to check drum seal. |
- Belt should be centered and tight on |
dryer drum. |
- Wire clips which hold the door switch wires |
must be anchored in sbt in top of front |
panel (see view C) and abng top edge of |
side panel. Door wires must not touch drum |
when dryer is operating. See Warning, |
page 15. |
8. Replace top panel and lint screen screws. Top |
and front panels must be securely in place |
before operating dryer. |
9. Reconnect power and level dryer again |
(ii necessary). |
NOTE: Call Consumer Assistance at
Drum 00~1 | 8ldel panel |
Wire dip- hotdsdoor
View8
VIewD
16