Whirlpool GR450LXH manual Troubleshooting, Storage Drawer, To Replace, To Remove

Models: GR450LXH

1 20
Download 20 pages 20.31 Kb
Page 18
Image 18
To Replace:

3.Push door down and pull straight out to remove door completely.

4" (10 cm)

To Replace:

1.Hold oven door by the handle and place the top of the door under the cooktop overhang.

2.Use front of leg to apply pressure to slide hinges into the slots as far as possible.

3.Use side of leg to apply pressure to the bottom of the door front.

4.Lift door slightly. Apply pressure and push until the hinges have gone in fully.

Storage Drawer

The storage drawer can be removed. Before removing, make sure drawer is cool and empty.

To Remove:

1.Pull drawer straight out to the first stop.

2.Lift up the back of the drawer and pull out.

To Replace:

1.Fit the ends of the drawer rails into the guides in the cavity.

2.Slide the drawer closed.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

Is the power supply cord unplugged? Plug into a grounded outlet.

Has a household fuse been blown or has the circuit breaker been tripped?

Replace the fuse or reset the circuit.

Cooktop will not operate

Is the control knob set correctly? Push in knob before turning to a setting.

On ceramic glass models, is the “Cooktop Lockout” set? See “Cooktop Lockout” section.

Right front surface cooking area will not operate

Cannot boil on right front surface cooking area? Press the ACCUSIMMER™ switch to OFF. Turn right front control knob to HI for a rapid boil.

ACCUSIMMER will not simmer?

Turn right front control knob on between the ACCUSIMMER LO and 4 settings, while pressing the ACCUSIMMER switch on.

ACCUSIMMER surface cooking area does not get hot enough?

Turn right front control knob to 4 while pressing the ACCUSIMMER switch on.

Excessive heat around cookware on cooktop

Is the cookware the proper size?

Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than 1 in. (2.5 cm) outside the cooking area.

Hot Surface Indicator Light Stays On

Does the Hot Surface Indicator Light Stay on after control knob(s) have been turned off?

See “Cooktop Controls” section.

Cooktop cooking results not what expected

Is the proper cookware being used? See “Cookware” section.

Is the control knob set to the proper heat level? See “Cooktop Controls” section.

Is the appliance level?

Level the appliance. See the Installation Instructions.

Oven will not operate

Is the electronic oven control set correctly? See “Electronic Oven Control” section.

Has a delay start been set? See “Timed Cooking” section.

On some models, is the Control Lock set? See “Control Lock” section.

Oven temperature too high or too low

Does the oven temperature calibration need adjustment? See “Oven Temperature Control” section.

On some models, does the cooling fan run during BAKE, BROIL or CLEAN?

It is normal for the fan to automatically run when the oven is in use. These helps cool the electronic control.

18

Page 18
Image 18
Whirlpool GR450LXH manual Troubleshooting, Storage Drawer, To Replace, To Remove