ELECTRONIC OVEN CONTROL
1. | Display | 5. | Oven Light Pad | 8. | Warming Drawer (on some models) | 11. | Hour/Minute |
2. | Timer | 6. | Sequence Programming (on some models) | 9. | Temperature | 12. | Start/Control Lock |
3. | Clock | 7. | Oven Settings | 10. | Timed Cooking | 13. | Cancel |
4. | Auto Clean |
|
|
|
|
|
|
Display
When power is first supplied to the appliance, “PF” and the current time will appear on the display. Press any pad to clear “PF” from the display.
Any other time “PF” appears, a power failure has occurred. Press any pad and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show either hours and minutes, or minutes and seconds.
Start
The START pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.
Cancel
The CANCEL pad stops any function except the Clock, Timer and Control Lock.
Clock
This is a
To Set:
Before setting, make sure the oven and Timer are off.
1.Press CLOCK.
2.Press the HR or MIN “up” or “down” arrow pads to set the time of day, including a.m. or p.m.
3.Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
■Valid pad press
■Oven is preheated (long tone)
■Function has been entered
Three tones
■Invalid pad press
Four tones
■End of cycle
■Reminder, repeating each minute after the
Reminder Tones
Reminder tones may be turned off. Press and hold STOP TIME for 5 seconds. “rEP OFF” will appear in the display. Repeat to turn reminder tones back on, and “rEP on” will appear in the display.
All Tones
All of the above tones are preset on, all except the
To Turn Off/On: Press and hold START TIME for 5 seconds. A tone will sound and “Snd OFF” will appear on the display. Repeat to turn tones on and “Snd on” will appear on the display.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will sound and “°C” will appear on the display. Repeat to change back to Fahrenheit. To exit mode, press CANCEL.
8