7.Tip the terminal box cover at the screw flange area to remove. Remove the terminal box cover and set it aside.
A
A. Terminal box cover
8.Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL Listed or CSA approved ¹⁄₂” strain relief.
A
A. Power supply knockout
9.Using 2 or more people, lift the hood into final position. Feed enough electrical wire through the ½" UL listed or CSA approved strain relief to make connections in the terminal box. Tighten the strain relief screws.
10.Position the range hood so that the large end of the keyhole slots are over the mounting screws. Then push the hood toward the wall so that the screws are in the neck of the slots. Tighten the mounting screws, making sure the screws are in the narrow neck of slots.
11.Connect ventwork to hood. Seal joints with clamps to make secure and airtight.
12.Check that back draft dampers work properly.
MakeElectrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
E
A 
B
C
DF
A. White wires
B. Black wires
C. UL listed wire connector
D. Green (or bare) and
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief
2.Use UL listed wire connectors and connect white wires (A) together.
3.Use UL listed wire connectors and connect black wires (B) together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in terminal box.
Failure to do so can result in death or electrical shock.
4.Connect green (or bare) ground wire from home power supply to
5.Reinstall terminal box cover.
6.Check that the light bulb is secure in its socket. See "Replacing the Fluorescent Lamp" in the Range Hood Care section.
7.Reconnect power.
CompleteInstallation
1.Replace grease filters. See the “Range Hood Care” section.
2.Check the operation of the range hood fan and light. See “Range Hood Use” section.
If range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown. Disconnect power and check wiring connections.
NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.
10
