5. Electrical requirements
Observe all governing codes and ordinances.
A 120 Volt, 60 Hz, AC only, 15 amp fused electrical supply is required.
recommended.) It is recommended that a separate circuit serving only this appliance be provided.
6.GROUNDING INSTRUCTIONS
WARNING. | Improper | use | of the grounding | plug can result | in | a risk | of | ||||
’ | electrical | shock. |
|
|
|
|
|
|
| ||
| An extension | cord | should | not | be used | with this | appliance. | ||||
| Such | use | may | result | in a | fire, | electrical | shock | or | other | per- |
| sonal | injury. |
|
|
|
|
|
|
|
| |
DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER
SUPPLY CORD GROUNDING PRONG.
7.For your personal safety, this appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire forthe elec-
tric current. This appliance is equipped with a
&PRONG
WALL RECEPTACLE
GPOUNDING
POWER SUPPLY
8.Plug the oven into the proper elec- trical outlet and put about one cup
(250 mL) of cold water in a glass container in the oven. Close the door. Make sure it latches. Fol- low the directions on page 6 to set the oven to COCK for II/Z minutes. When the time is up, the water should be heated.
polarized
prong grounding type wall receptacle, prop- erly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall recep- tacle is not available or if you are not sure if the
wall receptacle is properly grounded and
polarized, have it checked by a qualified electrician.
It is the personal responsibility and obligation of the customer to have a properly grounded and correctly polarized
Consult a qualified electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded.
9.This microwave oven is designed for use in the household only and must not be used for
commercial purposes.
DO NOT remove the outer case, door, or con- trol panel at any time. The unit is equipped with high voltage and should not be serviced unless
by an authorized Whirlpool trained service technician.
