Programming tone
Each time you touch a pad you will hear a tone. If you do not hear a tone,
it is because the instruction is not correct, or it is because the tones have been removed
EXAMPLE: If you touch a Number Pad before You touch a Command Pad, You will not hear a tone. The instruction is not correct.
If you want to remove the tone:
lOpen the door.
l Touch CANCEL twice, then START. l The tone will not sound for any
touch.
If you want to replace the tone:
. Open the door.
l Touch CANCEL twice, then START. l The tone will sound for any correct
touch.
Setting the clock
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric
power ever goes off, the ClockDisplay will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
The Display will show a “0”and the colon will start to flash. the first Number Pad must be touched wlthln 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
2.Touch Number Pads for the correct time of day.
3.Touch START.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
If you have touched in an incorrect time, such as12.65. “Err”will show on the Display. Touch CLOCK SETand start over.
