Whirlpool RB22CK Removing crispers and crisper cover, Changing the light bulbs, To removecover

Removing meat drawer and Removing freezer basket

cOver-nu

To removemeatdrawer:

1.Slide out to the stop.

2.Lift the front.

3.Shde out the rest of the way.

4.Replace in reverse order.

To remove cover:

1.Tilt front of cover up, lift at back and pull straight out.

2.Replace in reverse order.

Removing crispers and crisper cover

To remove basket:

1.Slide out to the stop.

2.Lift the front to clear the stop.

3.Slide out the rest of the way.

To replace basket:

1.Place basket on the slides.

2.Make sure the wire stops clear the front of the slides.

3.Slide basket in.

Changing the light bulbs

I mectricaIshfxkHazard I

Unplug the refigerator or discon- nect the main electric power supPly to the reftigerator before changing a

~bulb. Failure to do BOcould result in electrical shock or MUIY.

To change freezer light:

1.Disconnect refrigerator from power -..--1w.

2.Push in sides of light shield until it snaps free.

3.Replacebulb with a 40-watt appliance bulb.

4.Snaplight shield into place.

5.Reconnect power supply.

NOTE: Not all commercial appliance bulbs will fit your refrigerator. Be sure to replace a bulb with one of the same size and shape.

Removing the base grille

To removeuisper:

1.Slide out to the stop.

2.Lift the front.

3.Slide out the rest of the way.

4.Replace in reverse order.

To removecover:

1.Push up glass insert from bottom, then lift out with two hands.

2.Lift front of cover frame.

3.Pull cover frame up and out.

4.Remove metal cover support.

To replace wver:

1.Replace metal cover support on wall supports in front section of cabinet.

2.Fit back of cover frame into notch supports on walls of refrigerator, then lower into place.

3.Slide back of glass insert into place, then lower front.

To change refrigerator light:

1.Disconnect refrigerator from power supply.

2.Push lightly on the top center of the light shield until the notched tab unhooks from the control nanel.

3.Pull down on the light shield until the tab clears the control panel.

4.Lift back hooks out of their slots.

5.Remove bulb and replace with a 40-watt appliance bulb.

6.Replace light shield in reverse order.

7.Reconnect power supply.

To removefpille:

1.Open freezer door.

2.Pull grille out.

3.Do not remove Tech Sheet fastened bebind grille.

To replace grille:

1.Line up grille support tabs with metal clips.

2.Push firmly to snap into place.

3.Close the door.

Seecleaning insmctions for defrost pan and condenser coils on page 7.

Reversingthe door swing

You can change the hinges on your refrigerator so the doors open the other way. Refer to the instruction sheet included with your refrigerator.

Ice cube trays

Removeice by slightly twisting the tray with both hands.

NOTE: The longer ice cubes are stored, the smaller they get. Slow evaporation is caused by the movement of cold air.

Page 5