How to remove and replace modules
Make sure all Surface Unit Control Knobs are in the “OFF” position and the modules are cool before removing or replacing.
To remove or replace Surface Unit Modules
1. To remove:
l Lift module using the handle at the front. (See Step 1.) Raise front
Step 1 | just high enough to grasp at front edge. |
|
lEase module toward you using both hands to unplug it. (See Step 2.)
lLift module out of cooktop. It may be used in any cooktop position (left. right or center on the three module unrt)
2.To replace:
lGrasp module with both hands (See Step 2. )
*Ease it into place, lining the module terminal with the receptacle on
Step 2 | the cooktop (See Step 3.) |
/’ | |
l | Lower the module. using the handle on the front. (See Step 1.) |
To remove or replace a Grill Module
Make sure the Module Control Knob is in the “OFF” position and the module is cool before removing or replacing.
Step 3
Step 1
Step 2
1. To remove:
lLjft the grill off the grill frame. (See Step 1.)
0 Grasp the heating element with both hands, lifting slightly. Pull toward you to unplug the heating element.(See Step 2.)
lLrft ceramic rcIrk basket from grease well. using basket handle. (See Step 3.1
Remove grease well by lifting the module using the handle at the back. Slide grease well back about one inch and up until the tab on the front edge is clear of the cooktop frame. (See Step 4.)
Lift grease well out of the cooktop. Remove as directed to avoid spills of fat drippings. Clean all parts after each use. (See page 10. “How to clean and care for your cooktop.“)
,2. To replace:
lRest grill frame on rile cooktop frame Raise slightly at rear. Hold h,3ndle and slide for\Lard until it stops. (See Step 5.) The front tab
~l~ould slide under the cooktop frame. Release handle to lower grill Frame
lUsing the har!tile. lower the ceramic rock basket into the grill frame. (See Step 13 Slide basket to the front of the grill frame, ieaving enough room to plug the heating element into the cooktop
lGrasp the heating element with both hands and plug terminal into
cooktop receptacle (See Step 2. ) Lower into place.
lFit grill into groove on top of the frame. Be sure that center support- ing bar on the grill faces down.
Step 3 | Step 4 | Step 5 |
