,WIRING DONE ACCORDING TO
NATIONAL ELECTRICAL CODE
AND APPLICABLE LOCAL CODES1
RECEPTACLE
TERMINAL
ACCESS
COYER
Figure 13
INSTALLING MICROWAVE
OVEN
1.Place the microwave oven on the shelf hood in the center of the hood.
2.Use the leveling bolts provided to level the shelf hood after the weight of the appliance is placed on it. Bolts are provided in the installation Assembly. Screw the bolts into the nuts
FILTER REMOVAL AND
INSTALLATION
The aluminum filter is held in place with the two filter clips located on the front panel. (See illustrations below).
To remove the filter, simply turn the filter clips to the front of the hood. The filter can now be removed.
To replace the filter, place one end of the filter beneath the back flange of the panel and set filter in position. The filter will set over the blower housing with the other end flush on the lower flange of the front panel. Turn the filter clips to the rear until the filter is secure.
FILTER CLIPS
FILTER INSTALLED
Figure 15
FILTER CLIP /
Figure 16
Figure 14
provided on the lower left and right hand sides of the hood until the unit is level. (Figure 14) Use a level.
NOTE: The leveling bolts have a 9116” Hex Head.
CAUTION: The mlcrowave oven must be level from front to back to minimize utensils from sliding forward when openlng the door.
WARNING: THE WEIGHT OF THE MICROWAVE MAY EXCEED YOUR LIFTING ABILITY. WE RECOMMEND ASSISTANCE.
3. Replace front panel. (Figure 10)
LIGHTING
Select two light bulbs up to 60 watts each to achieve the desired lighting.
The bulbs may be installed or removed by removing the filter.
Once the filter is removed, adequate space is provided on either side of the filter area for installation or removal of the bulbs by hand.
BLOWER
HOUSING
F’LTER
FILTER INSTALLATION
Figure 17
Page 5
