VENTED KITCHEN SHELF HOOD FOR 120 V. OPERATION
KITCHEN
RANGE HOOD
I MODEL
IMPORTANT
FOR VENTLESS INSTALLATION, DIS-RH3330XL-1
REGARD THIS INSTRUCTION SHEET.
USE VENTLESS KIT INSTRUCTION
SHEET FOR MODEL RCH3660.
READ AND SAVE THESE INSTRUCTIONS
Before you begin, read the following instructions completely and carefully. It followed, they will simplify the installation job.
‘PJJORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
FOR USE WITH WHIRLPOOL “J” AND “L”
LINE MICROWAVE OVENS
BEFORE YOU USE YOUR SHELF HOOD:
Be sure your shelf hood is installed on an appropriate wall strong enough to support this appliance.
NOTE: The shelf hood is designed to support a microwave oven with a net weight of up to 75 pounds, plus approved accessories, cookbooks, utensils, and food.
The area used for the installation must be suitable for the size, function, and protection (from elements) of the shelf hood.
WARNING: THE WEIGHT OF THE MICROWAVE MAY EXCEED YOUR LIFTING ABILITY. WE RECOMMEND ASSISTANCE.
CAUTION: When mounting the shelf hood to a wall, you must locate 2 studs in the wall. Do not attempt to install the hood if the 2 wall studs are not found.
FOR USE OVER WHIRLPOOL CONVENTIONAL GAS AND ELECTRIC RANGE COOKTOPS
Be careful when drilling holes into awall. Electrical wires and water pipes may be concealed behind the wall covering.
-TOOLS AND MATERIALS REQUIRED
l Drill, electric or ratchet drive, with 3/8”, 3/16” and l/8” wood bit (for drilling starter holes) and
l One common and one phillips head screwdriver (to secure hood mounting screws to the cabinet and hood sheet metal parts).
l Pliers (for opening knockouts).
l
l
l
Pencil, ruler and level for marking cabinet locations.
Saber saw or keyhoie saw for cutting the wall or cabinet openings.
Caulking, metal snips, duct tape, ducts (with elbow and transition, if necessary) and wall cap or roof cap, as required.
3/ 79 | Page 1 |
