1.Unplug power cord.
2.Remove front panel. (See page 5.)
3.Slide unit out of cabinet by using the handle in the center of the base flange.
4.Wrap the motor, connector plug, electrical control box and compressor terminal box in plastic film and make sure no water or other liquid gets inside any of these parts. lt could damage the insulation and cause serious mechanical problems.
5.Carefully clean and hose out the base, condenser coil and condensate pans. Clean at least once a year or more often if the con-
denser coil and pan collects dirt, sand, leaves,
Handleinsects or algae. Also, clean if you detect an odor coming from the air conditioner.
6.Remove plastic film from motor and electrical parts.
7.Replace unit in cabinet.
8.Replace front panel.
9.Reconnect power supply.
NOTE: lt is a good idea to wait 24 hours before starting the unit again. This allows time for all areas to dry out. The water from rainfall or from normal operation does not harm these compo- nents.
