Make Electrical Connection
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in terminal box.
Failure to do so can result in death, fire, or electrical shock.
Complete Installation
Install 75-watt (max.) incandescent light bulb.
1.Squeeze the plastic lens cover and remove it from the hood.
A B
A. Light bulb socket
B. Lens cover
2.Screw light bulb into socket.
3.Replace lens cover by squeezing cover and inserting tabs into slots.
Direct Wire Installation
1.Connect the white wire of the home power supply with the white wire in the range hood using a UL listed
B
A
C
D
E
A. White wires
B. Black wires
C. Green ground screw
D. Ground wire
E. UL listed or CSA approved strain relief
2.Connect the black wire of the home power supply with the black wire in the range hood using a UL listed
3.Connect ground wire (green or bare) of home power supply to the green ground screw in the terminal box.
4.Tighten strain relief screws.
5.Install the terminal box cover.
6.Reconnect power.
Install Charcoal filter
For non-vented (recirculating) installations:
Install charcoal filter pad Part Number 4396846 available from your dealer. See “Range Hood Care” section for installation instructions.
Check Range Hood Operation
1.Check light operation by turning the light knob.
2.Check operation of fan by turning the fan knob.
3.If the range hood does not operate, check to see whether a circuit breaker has tripped or a house fuse has blown.
4.NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
The hood controls are located on the front
AB
A. Fan control
B. Light control
10