Whirlpool RHH 4300 operating instructions Installation Instructions, To Install Range Hood, f or

INSTALLATION

and

OPERATING INSTRUCTIONS

f or

whirlpool CONVERTIBLE RANGE HOOD

RHH 4300 SERIES

INSTALLATION INSTRUCTIONS

Your range hood has been designed to filter out smoke, odors and grease which rise from the cooking surface.

Before you begin the installation be sure that all parts and

accessories are removed from carton. For best results and

ease in the installation of this range hood, read the

instructions sheet to become familar with the step by step installation.

TOOLS REQUIRED FOR INSTALLATION OF HOOD: A standard slot head screw driver, punch or ice pick, drill with X-inch bit, keyhole saw and a ruler or tape measure.

TO INSTALL RANGE HOOD

YOUR HOOD CAN BE INSTALLED VENTLESS WHERE AIR IS

CIRCULATED BACK INTO THE ROOM THROUGH THE FILTER OR VENTED WHERE AIR IS TAKEN OUT OF YOUR

KITCHEN. For most efficient operation, top of hood should be

approximately 66 inches (137.6 cm) from the floor.

1.For vented applications, see Figures 4, 5, and 6. Typical

vented	installations		are		shown	for the 7”		Round Vertical,
3% x	10	Vertical,	and	the 3%		x 10	Horizontal		Discharge
respectively.		Choose		the	best	method	for	your	installation.

2.Mark locations on cabinet or wall for ventilating duct and

electrical wiring from dimensions given in Figure 1.

3.Cut holes at marked locations to accomodate ventilating

duct and electrrcal wiring. Allow %” (1.91 cm) extra on

ventilating opening toward the front of cabinet directly above the hood. Be sure to minimize openings through outside walls or the ceiling. These will have to be sealed later. Figure 2 shows cabinet cutouts for the 3% x 10 Vertical Venting.

4.Run wire through wall or cabinets according to the

National Electrrcal Code and applicable local codes. DO

NOT turn power on until installation is complete.

5.Remove screws holdrng junction box cover. See Figure 6.

6.Lift the hood into posrtion and mark the hole locations on the cabinet for each of the four keyhole mounting slots.

KEYHOLE SLOT

IN CANOPY

FIG. 3

SCREW\

(IN INSTALLATION PARTS BAG)

KNOCKOUT	FOR 7” (15.8 CM)
ROUND	VENTING	7	x

REAR OF HOOD

&,R,NG KNOCKOUTS

FIG. 1

A CABINET CUTOUTS

LSTARTER HOLES

FIG. 2