INSTALLATION and OPERATING INSTRUCTIONS
f or
%hpool VENTLESS RANGE HOOD RHH 7630
TO INSTALL RANGE HOOD
For an easier installation, remove the filters and the three
assemblies shown in Fig. 3. This reduces theweight about 40%. The blower cover and light frame assembly are held into place by spring latches. To remove simply grasp and
pull as indicated in Figure 3. To remove the blower
assembly, first unplug the blower powersupply cord from the junction box. Then pull the blower retaining rod to one side, freeing it from between the bumps on the blower housing.
1.Remove screw holding junction box cover.
2.Remove proper electrical knockout. See Figure 1
3.Lift the hood into position. Mark location of four
mounting holes.
4.Remove hood and start all four screws in center of narrow neck of keyhole slot marked on cabinet bottom (Fig. 2).
5.Lift into position on four screws simultaneously
feeding electrical wire through knockout.
6.Complete electrical wiring in junction box according
to the National Electrical Code and applicable Local
Codes, NOTE: Thus Unit must be permanently grounded.
7.Tighten screws to secure hood. Be sure screw head is in narrow neck of keyhole slot.
8.Replace junction box cover
9.Replace blower cover, light frame assembly and filters.
10.Replace blower.
KEYHOLE SLOT
IN CANOPY
SCREW1 (IN INSTALLATION
PARTS BAG)
L WIRING KNOCKOUTS
FIG. 1
LIGHT | 7 |
| LIGHT | FRAI\:E |
SWITCH |
| ’ | ASSEMBLY | |
|
|
|
- JUNCTlOh @OX
|
| |
|
| |
‘COVER | ‘EILOhER | CRADLE |
FIG. 3