Whirlpool RIE360B manual To stop the cleaning cycle after it has started

Special tips:

l

l

l

l

l l l

If the cleaning cycle doesn’t get the oven as clean as it should be, the time set for cleaning was probably not long enough. Set the cleaning time longer next time. You can set it for more than 3 hours. if you want.

Plan to clean the oven before it gets too heavily soiled. Other- wise. you may notice more smoke than you would expect com- ing from the oven vent. And. the cleaning cycle has to be longer to clean a very soiled oven

There will be normal “heatodors“ during the cleaning cycle. To help get rid of them. keep the kitchen well ventilated.

To stop the cleaning cycle after it has started:

-Turn the Stop Time Knob to the right time of day. --Turn the Oven Selector Knob to “OFF.”

--Turn the Oven Temperature Control Knob to “OFF.”

--.-Unlock and open the oven door when the Lock Light turns off

NOTE: Do not force the Lock Lever. Wait until it moves easily. Do not use foil or other oven liners in your Self-Cleaning Oven. Don-t use commercial oven cleaners in your Self-Cleaning Oven. If racks are left in the oven during a cleaning cycle. they will lose their shine. discolor and be harder to slide in and out. To make them slide easiclr. polish the edges of the racks and rack guides with a soapfilled steel wool pad. rinse well. and wipe on a thin coating of s&d oil

Pull knob and trim ring straight out. Remember how the spring goes.

Cleaning and caring for your range

Your range is designed to be easy to clean. You will usually wipe off spills and spatters when they happen. but you will sometimes want to clean under and behlnd the control knobs and surface units. This section will tell you how to remove those. and what to use when cleaning.

Removing and replacing surface unit control knobs:

1, Be sure the control knobs are set to “OFF.”

2.Pull straight out on the black knobs.

3.If the control has a chrome trim ring. pull it straight out.

4.Wash the knobs (and trim rings) in warm. sudsy water.

5.Replace the trim rings first. If the control spring was removed, put it back exactly as shown on the left...smaII end first.

6.Hold the black knob so it points to “OFF” Push it straight back on.

Removing and replacing oven control knobs:

1.Be sure the knobs are set to “OFF.”

2.Pull each knob straight off.

1% Wash the knobs In warm, sudsy water.

4.The knobs are not interchangeable. Make sure you put the adjust- able Oven Temperature Control Knob on the right place. and the nonadjustable Oven Selector Knob on the other.

12