Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power source, install it and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except the model and serial number label) before using the refrigerator.
NOTE: Do not remove any permanent instruction labels inside your refrigerator. Do not remove the Tech Sheet fastened under the refrigerator at the front.
To remove any remaining glue: | Cleaning | it before | use |
l Rub briskly with thumb to make a ball, then remove.
OR
l Soak area with liquid hand dishwashing detergent before removing glue as described above. Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. These can damage the material. See ‘Important Safety Instructions” on page 3.
After removing all packag- ing materials, clean your refrigerator before using it, if necessary. See cleaning instructions on pages
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.
See Electrical Requirements and Ground- ing Instructions Sheet in your Literature Package.
WITH QUESTIONS OR COMMENTS
