Adjusting the crisper cover track
&cause your crispers are not the same size, your crisper cover has an adjustable center track so you can swftch positbns of the crispers.
To remove the center track:
1.Push up the cover insert from the bottom, then slide out with both hands.
2.Gently pull up on front end of the center track.
3.Pull rear end of track out of opening in cover.
To replace the center track:
1.Insert rear end of track (with hole) into opening in cover.
2.Lower front end of track into slot.
3.Make sure rear end of track has snapped into place on under side of cover.
Using the ice cube trays
If cubes are not used, they may shrink. The moving cold air starts a sbw evapxatbn.
The longer you store cubes, the smaller they get.
To remove ice:
1.Hold tray at both ends.
2.Twist slightly.
Using the optional automatic ice maker
If your refrigerator has an automatic be maker, or if you plan to add one later, here are a few things you will want to know.
lThe ON/OFF lever is a wire signal arm.
DOWN to make be automaticalfy UP to shut off the be maker
IMPORTANT: Do not turn on the be maker until it is connected to the water supply. Instructions for ks msker water supply hook up are attached to the back of the refrigerator cabinet.
12
