Removing the crisper and cover

To remove the crisper:

1.Slide crisper straight out.

2.Replace crisper by sliding it straight in.

To retnove the cover:

1.Lift the back and slide it to the rear until the front can be lifted.

2.Lii cover up and out.

To replace the cover:

1.Slide the front cover tabs into the rear of the front supports on the refrigerator walls.

2.Lower back of cover into place.

Using the ice cube trays

If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove ice:

1.Hold tray at both ends.

2.Twist slightly.

Using the optional automatic ice maker

If you plan to add an automatic ice maker later (Part No. IMKIT), there are a few things you will want to know:

l The ON/OFF lever is a wire signal arm. Down ... to make ice automatically.

up ... to shut off the ice maker.

. .

NOTE: Do not Ucn ice Won until It IS

Gonnected to the water wwl~. lnstructlons hook up WC

mached to the back of the refrigerator cabinet.

lThe dial or lever on the side of the ice maker changes the size of the cubes.

l Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity.

lIt is normal for ice crescents to be attached by a corner. They will break apart easily.

l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

Raise signal arm to stop ice.

Lower signal arm to start it

Page 9
Image 9
Whirlpool RTIZDK Removing the crisper and cover, Using the ice cube trays, Using the optional automatic ice maker