Preparing for Installation
1.Remove the two bottom screws in the access panel/toeplate (see Figure 3).
2.Open the dishwasher door and remove the two top screws.
3.Close the door. The access panel can now be removed by pulling it forward.
4.Remove four screws to remove the toeplate.
5.If required, install a 90” elbow (not included) into the water valve. Use Teflon@ tape to seal the elbow into the valve fitting. Valve fitting is 3/~” National Pipe Thread.
Changing Color Panels
Select models are equipped with reversible door and access panel inserts that offer three decorative colors. To change exposed color panel, proceed as follows. It is best to change color panels before ins tailing dish washer.
NOTE: Handle panels carefully to avoid injury or cuts.
1.Remove frame strip from one side of the door panel. Loosen, but do not remove screws from frame strip on remaining side (see Figure 4).
2.Remove frame strip from one side of the access panel. Loosen, but do not remove screws from frame strip on remaining side (see Figure 4).
3.Slide insert panels out of frame. Put color panel of choice to outside and replace panel in frame.
4.Be sure edges of insert panels are under frame strips on opposite side. Press strips tightly against panels before securing screws. Replace frame strips.
For best appearance, remove the protective film covering the frame strips after installing your dishwasher.
5
