COOKTOP USE

CooktopControls

WARNING

Fire Hazard

Do not let the burner flame extend beyond the edge of the pan.

Turn off all controls when not cooking.

Failure to follow these instructions can result in death or fire.

IMPORTANT: Your cooktop is factory-set for use with Natural gas. If you wish to use LP gas, an LP Gas Conversion Kit is included with your new cooktop. See the instructions included with the LP Gas Conversion Kit for details on making this conversion.

Electric igniters automatically light the surface burners when control knobs are turned to LITE.

The large burners (12,000 Btu/h [British Thermal Units]) provide the highest heat setting, and are ideal for cooking large quantities of food or liquid, using large pots and pans. The small burners (9,100 Btu/h and 6,000 Btu/h) allow more accurate simmer control at the lowest setting, and are ideal for cooking smaller quantities of food, using smaller pots and pans.

Before setting a control knob, place filled cookware on the grate. Do not operate a burner while using empty cookware or without any cookware on the grate.

NOTE: Visually check that the burner has lit. If the burner does not ignite, listen for a clicking sound. If you do not hear the igniter click, turn the burner off. Check for a tripped circuit breaker or blown household fuse.

Check that the control knob is pressed completely down on the valve shaft. If the spark igniter still does not operate, call a trained repair specialist.

Proper grounding and polarity are necessary for correct operation of the electric ignition system. If the wall receptacle does not provide correct polarity, the igniter will become grounded and occasionally click, even after the burner has ignited. Contact a trained repair specialist to check the wall receptacle to see whether it is wired with the correct polarity.

To Set:

1.Push in and turn knob counterclockwise to LITE.

All surface burners will click. Only the burner with the control knob turned to LITE will produce a flame.

2.Turn knob anywhere between HI and LO. Use the following chart as a guide when setting heat levels.

SETTING

RECOMMENDED USE

 

 

 

Lite

Light the burner.

 

 

 

Hi

Start food cooking.

 

Bring liquid to a boil.

 

 

 

Medium High

Hold a rapid boil.

Between Med & Hi

Quickly brown or sear food.

 

 

 

 

Med

Fry or sauté foods.

Medium

Maintain a slow boil.

 

 

Cook soups, sauces and gravies.

 

 

 

Medium Low

Stew or steam foods.

Between Med & Lo

Simmer.

 

 

 

 

Lo

Keep food warm.

 

 

 

REMEMBER: When cooktop is in use, the entire cooktop area may become hot.

Power failure

In case of prolonged power failure, the surface burners can be lit manually. Hold a lit match near a burner and turn knob counterclockwise to LITE. After burner lights, turn knob to setting. Do not use a grill or griddle accessory during a power failure, as the vent fan will not operate.

SealedSurfaceBurners

IMPORTANT: Do not obstruct the flow of combustion and ventilation air around the burner grate edges.

Burner cap: Always keep the burner cap in place when using a surface burner. A clean burner cap will help avoid poor ignition and uneven flames. Always clean the burner cap after a spillover and routinely remove and clean the caps according to the “General Cleaning” section.

A

C

B

D

E

A. Burner cap

D. Burner base

B. Alignment pins

E. Gas tube opening

C. Igniter

 

6

Page 6
Image 6
Whirlpool SCS3617, SCS3017, GLT3657 manual Cooktop USE, CooktopControls, SealedSurfaceBurners, To Set, Power failure