Whirlpool 806, Series 400, 830 warranty Stopping the dishwasher

1.	Load	the	dishwasher.		See the “Loading
			Your	Dishwasher”		section. -
2.	Spin	the	spray	arm.	ltshould	turn freely.

7. Select a drying option. (See the “Setting

	i&Z	the Controls”		section.) For
		models with		buttons,	the
	r;
		indicator	above the		button
		will show red when the option
Ed		has been	selected.		For
	models with rocker switches, the switch
	indicates which option has been selected.

NOTE: Select Air Dry for the Rinse &

=--=

Hold cycle. For Series 840 models, push a Cycle button

3. Add detergent. See the “Using the

-Dispensers” section.

4.Add rinse agent, if needed.

5.Close door firmly until it latches.

6.Run hot water at the sink nearest the dishwasher until water is hot. Turn off water.

Kfor the desired cycle. Normal Wash, Light Wash, and Rinse

F3& Hold cycles share the same

button. The Cycle Control Knob deter- mines which cycle operates. For Series 830 models, the Heat Dry option is automatically selected with the Pots & Pans cycle.

8.Turn the Cycle Control Knob clockwise to the desired cycle. You will feel a definite “stop” at each cycle mark. The dishwasher automatically starts the cycle you select.

NOTE: If the door is latched, you will hear the cycles start and stop as the control knob passes each cycle mark. This is normal and does not hurt the dishwasher. If you prefer, you can set the Cycle Control Knob with the door unlatched.

Stopping the dishwasher

You can stop your dishwasher anytime during a cycle. All you have to do is:

l Open the door slightly. Wait for any filling or spraying action to stop before opening the door all the way. Close the door to continue the cycle.

OR

l Turn the Cycle Control Knob slowly clockwise until you hear water draining.

Let the dishwasher drain completely. Then open the door and turn the Cycle Control Knob to Off.