Operating Your Washer In This Section PWP PW
Boforo sbriing
your wrher ..............................
5 Using rinm nd spin ........................................ 8
8tuting or stopping your washw .................... .5 lhiidrainndmpin ....................................... 8
8sko8ngakads~ .......................................... 5 What happena in each cyck ........................... 8
8doc8ng 9 wnh tsmpudun ................... . ...... 8 Udng itm chbodns bksoh diopsnsu ............ .8
Mocting a cyck md lima ................... . ............ 7
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a
sorted load in the washer before starting. See page 10 for additional “Before you wash”
information.
Starting or stopping your washer
Startlng your wahu:
1.
Select a load size (see below).
Wash w&r bmpuaturo
2. Push in the Cycle Control Knob and turn it
cloclovise. Stop when the indicator on the knob’s -0 I
outer ring points to the number and wash water
temperature in the cycle you want. The numbers
are minutes of wash time. Wash water tempera-
ture is indicated by the letter near Fill (H=Hot,
W=Warm, C&old). (See pages 6-6.)
3. Pull out the Cycle Control Knob.
Stopping
and restarting your washer:
- To atop the washer at any time, push in the Cycle
Control Knob.
- To restart the washer, close the lid (if necessary)
and pull out the Cycle Control Knob.
Wash iims
Selecting a load size
Position the Load Size Selector at the setting that corresponds
to the size load you want to wash. Select a setting based upon
the size of the load and the fabric you are washing. See
pages 10 and 11 for additional loading infomation.
To change the load size setting after the washer has started to
fill, move the Selector to the desired new setting.
Load size tips
- Items should move freely during the wash. Do not overload the
machine or select a load size that is too small for the wash
load.
- Use the Large load size setting for best results with permanent
press clothes.
- Reduce wash time when using the Small load size setting.
Loads with only a few small items need less wash time.
5